Metal roofing
Architectural shingles
Tile roofing
GAF
Owens Corning
Flat & low-slopeFree roof inspection with deck photos before we talk money - GAF and Owens Corning certified installation
Styles & brands we work with
- Architectural shingles
- Metal roofing
- Tile roofing
- GAF
- Owens Corning
- Flat & low-slope
See the difference
Before
After
Before
After
Before
AfterNew Construction in Whitney, NV
New construction roofing in Whitney means installing a complete roof system on a home that has never had one – decking, underlayment, flashing, ventilation, and the finished shingle or tile surface – built to pass Whitney’s permitting inspections and stand up to the Mojave wind and summer sun. Shepherd & Sons Roofing Whitney handles new construction roofs for custom builds, additions, and infill lots across the east valley, and we do it with the same written 90-Day Done Right Promise we put on every job. If you’re building and need a roofer who answers his own phone, call (844) 797-9455. This work sits at the front end of our Roof Replacement and Installation service, and you can see the full scope of what we do on our Roof Replacement and Installation in Whitney page.
A new roof on a new house isn’t the same job as a tear-off. There’s no old material to remove, but there’s also no room for shortcuts – the first roof on a Whitney home sets the pattern for the next 20 to 25 years, and every layer has to be right the first time. Out-of-state outfits blow through after storm season and quote a number on the phone that changes at the door. You won’t see them at the hardware store on a Saturday. We’ve been at the same address since 1996, our name is on the license, and Bill Shepherd walks the deck with you before anyone talks money.
You can start from our home page if you’re still deciding whether to build, add on, or replace.
Key Takeaways
- New construction roofing in Whitney covers decking, underlayment, ventilation, flashing, and the finished surface – all inspected before the dry-in.
- A full new-home roof in Whitney typically runs $9,500 to $22,000 depending on square footage, pitch, and material.
- We install Owens Corning, IKO, Atlas, and Tamko systems and will pull the local permit and meet the inspector.
- Every new construction job carries the written 90-Day Done Right Promise.
When You Need New Construction
Most of our Whitney new construction calls come from a handful of situations. See if one of these sounds like you:
- You’re building a custom home on an infill lot. Whitney has been filling in between older parcels, and a lot that sat empty for years now has a foundation going up. That build needs a roofer who can work with your general contractor’s schedule and pass the county inspection the first time.
- You’re adding a room, a second story, or a garage. An addition creates a new roofline that has to tie cleanly into the existing one. That junction – the tie-in – is where leaks hide down the road, so it pays to have a roofer who treats it as its own job.
- Your general contractor doesn’t do roofing in-house. Plenty of builders sub out the roof and want a named, licensed roofer they can point to. We work directly with GCs and homeowners both.
- You’re replacing a build with a metal or tile roof from day one. Some homeowners in the east valley skip asphalt entirely and go straight to standing-seam metal or clay tile on a new build. We set both, and we’ll tell you honestly which holds up better to Whitney’s summer heat.
- A previous builder left the roof unfinished or under-built. We’ve seen new homes where the dry-in was rushed and the ventilation was never installed. Before we finish, we check the deck and the attic intake – the nailing pattern earns the wind rating, not the shingle wrapper.
- You want the roof measured and priced before framing is done. Getting a roofer in early means the pitch, valleys, and penetrations are planned around what makes a sound roof, not patched after the fact.
Our New Construction Process
Here’s how a new construction roof goes with us, in order. We don’t cut corners on the parts you can’t see, because that’s where a future leak lives.
- Walk the deck and plan the roof. Before any material shows up, Bill and the crew walk the framing with you and your builder. We check the pitch, count the squares, and note where valleys, skylights, and vents will land. A roof is measured in squares – ask any bidder how many they counted.
- Confirm materials with you. You’ll get a written scope naming the exact shingle, underlayment, and accessories. Want Owens Corning Duration, IKO Cambridge, Atlas Pinnacle, or Tamko Heritage? Name it and we’ve likely set it. Free Second Opinion on any other written estimate you’ve already got – no hassle, no trip charge inside our own county.
- Pull permits and meet the inspector. New construction requires inspection at specific stages – dry-in, flashing, and final. We handle the permit coordination and are on-site when the inspector comes, so a missing detail doesn’t stall your build.
- Install the dry-in and underlayment. Deck prep, ice-and-water where it belongs, then the underlayment layer. This is the part you’ll never see again, and it’s the part that matters most. We’ll show you photos before we cover it up.
- Set the finished roof. Shingle, metal, or tile – installed to the manufacturer’s spec so the wind and fire ratings hold. The guys on the roof are background-checked and uniformed, and Bill’s own sons are up there with him.
- Final inspection and walkthrough. We meet the inspector, hand you the paperwork, and walk the finished roof with you. If anything’s off in the first 90 days, one call brings Bill back.
New Construction Pricing in Whitney
New construction roofing in Whitney typically runs $9,500 to $22,000 for a whole-home install, and most single-story builds land between $11,000 and $16,000. Exact numbers depend on the roof, not a flat rate. Here’s what moves it:
- Roof area (squares): A 2,000 sq ft single-story Whitney home usually carries 22 to 26 squares of roof once you account for pitch and overhangs. Bigger footprint, bigger number.
- Roof pitch: A walkable 4/12 pitch is cheaper to install than a steep 8/12 or 10/12, because steep work takes longer and needs more safety rigging.
- Material choice: Architectural asphalt shingle from Atlas or Tamko sits at the lower end. Concrete tile or standing-seam metal runs $18,000 to $30,000-plus on the same footprint.
- Complexity: Valleys, dormers, skylights, and multiple roof planes add labor. A simple gable is the cheapest; a hip-and-valley plan with a second story costs more.
- Decking condition: On new construction the deck should be square and sound, but if a framing issue turns up, we’ll flag it before we start – not mid-job.
- Permit and inspection fees: Baked into the estimate, not tacked on later.
No trip charge inside our own county, and estimates are free. You’ll get the number before anyone touches your roof, so there are no surprises at the door.
FAQs – New Construction
How much does new construction roofing cost in Whitney?
New construction roofing in Whitney usually costs between $9,500 and $22,000 for a full-home install, with most single-story builds falling in the $11,000 to $16,000 range. Price depends on roof area, pitch, and material – asphalt shingle on the low end, tile or metal on the high end. Call (844) 797-9455 for a free estimate on your build.
Do you work with my general contractor or builder?
Yes – we work directly with general contractors and homeowners on new construction. Many Whitney builders sub out the roof rather than staff a crew in-house, and we’re glad to coordinate on framing schedule, permit inspections, and the final walkthrough. If you’re the homeowner, we’ll walk you through the scope so you’re not just hearing it secondhand from your builder.
How long does a new construction roof take?
A typical single-story Whitney home takes one to three days of install once the deck is dry and the permit’s pulled, with bidding and scheduling adding another week or two depending on the build calendar. Larger homes, tile, and metal take longer because the install is more involved. We’ll give you a real timeline in writing, not a best case.
Do you pull the permit and handle inspections?
Yes – we pull the roof permit and are on-site for the dry-in, flashing, and final inspections required for new construction. A roof that passes inspection the first time keeps your build on schedule, and we don’t hand that off. If anything on the deck needs correcting, we’ll flag it before we cover it up.
What shingle brands do you install on new construction?
We install Owens Corning, IKO, Atlas, and Tamko systems, plus CertainTeed, GAF, and Boral tile on specialty builds. Name the shingle and we’ve likely set it. We’ll show you the actual product going on your roof and the spec sheet behind the wind rating before you commit.
What if something goes wrong after the roof is done?
Every roofing job, new construction included, is backed by the written 90-Day Done Right Promise. If it’s not done right, we make it right – one call brings Bill back. That promise is in writing on the job, not handed over verbally.
Ready to talk through your build? Call (844) 797-9455 for a free estimate. A live person answers the phone 24/7 – nights, weekends, and after a storm – and Bill will come out, walk the deck, and give you a straight number before anyone touches your roof. Same address since 1996. Ask the storm chasers where theirs is.
Written by the team at Shepherd & Sons Roofing Whitney, serving Whitney.